This is my attempt to repair the Inductrix drone frame.

One of the motor mounts on the frame broke apart from the motor holder 🙁

Inductrix frame

So I removed the motor wires from the cirquit board, then removed propeller and the wire strap band, and pushed the motor out or the cylinder.

Inductrix motor and propeller

Then I use epoxy and applied to the broken part.

Epoxy glue fro drones
I held the broken piece in place until the epoxy mix dryied.

I waited about 1hr  just in case.

Drone motors

After it dried, I assemble it back and test it….


Drone inductrix fpv

Whooo, All done and ready to take over the livingroom sky again!!!!

Subscribe …\
our social pages

Youtube
Facebook
Instagram
Twitter